Originally Posted by hiphopfiend604
you have officially made my day!!!
if you post the specs...including amp specs...you will make my week!!!
Rated output @ 4 ohm - 80 watts
Rated output @ 2 ohm - 120 watts
18dB per octave low pass electronic crossover; continuously variable from 60hz to 250Hz
Third order Butterworth filter
High Level 2.4 volts to 25 volts RMS
Low Level 100mV to 1 volt RMS
Continuously variable gain control
Amplifier Frequency Response:
Crossover set at highest setting 15hz to 250Hz +0/-3dB
Crossover set at lowest setting 15Hz to 60 Hz +0/-3dB
Thermal; over voltage; under voltage; on PC board reverse voltage (25 amp fuse); in-line power fuse 25 amp; fused output to slave unit (5 amp)
Turn-On Circuit Requirements:
ON Threshold 2.2 Volts; ON Current 6 mA @ 13.8 Volts
High Level Input 400mV RMS
Low Level Input 18mV RMS
@ maximum output: 26 Amps
@ rated power w/4 Ohms load: 10 Amps
@ rated power w/2 Ohms load: 16 Amps
@ idle 0.9 Amps
@ standby 11 mA
Woofer Size 10"
Efficiency 104 dB
Dimensions: 21.1" x 10.3" x 12.2"
Magnet Size: 28 oz.
Weight: 25 lbs.