Go Back   Club Bazooka > Bazooka Technical Forums > Hook me up!


Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-09-2010, 01:34 PM
SCRAVEN's Avatar
Just Gettin Started
Join Date: Aug 2010
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 10
SCRAVEN is on a distinguished road
Default Bta10100fhc

Hi Everyone,

I have a couple of questions here and I want to be sure I do this all correct.

I am looking at buying and installing a BTA10100 tube/amp in my wife's car.

My Plan:
Connect the power directly to the battery via with a fuse. Connect the ground directly to the Frame of the car. Tap into the rear R/L +/- speaker wires and run those to the Highlevel imputs. Then finally connect the Orange Auto wire to the Antenna on wire on the back of the radio. Under this set up I will disconnect the Yellow jumper loop correct?

IF I have to run more wire to the battery I plan to use the same 16ga wire as the amp and connect via solder and heat shrink it.

Does this kit come with the "Fuse" part at I connect to the battery or will I need to buy a kit that contains that?

I have read the wiring instructions a couple of times but I want to be sure I understand correctly before starting this little project.


Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -5. The time now is 08:25 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.