Originally Posted by ions462
I’m trying to install my BTA850FH into a Kenwood KDC-MP342U that’s installed into a 2000 4runner but no luck. No sound coming from sub. I got the wire colors from the kenwood manual and I was just wondering how I should’ve tapped into the kenwood. And when I use the FAST-9999, should it connect directly into the wires coming out the back of the head unit and not the harness that connects the kenwood to the car, correct? Thanks!
Power Control/Motor Antenna control wire
(Blue/White) – P.CONT
TEL mute wire
(Brown) – MUTE
(Blue) – ANT. CONT.
And oh, one more thing, I noticed in the kenwood manual it says if subwoofer does not work its probably because the pre-out is not set to subwoofer. Damn, I should’ve read the Kenwood manual too before I quit for the day.
It doesn't matter if you connect to the factory harness or the harness of the headunit.
Your connections should go as follows:
Red power wire of the FAST-9999 - Yellow wire of the headunit
Blue/White wire of the FAST-9999 - Red wire of the headunit
Make sure you have an adequate ground, turn on the subwoofer function of the headunit and you should be good to go.