View Single Post
Old 12-19-2012, 01:44 AM
pimpg's Avatar
pimpg pimpg is offline
Just Gettin Started
Join Date: Dec 2012
Location: Atlanta
Posts: 3
Thanks: 1
Thanked 0 Times in 0 Posts
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 10
pimpg is on a distinguished road
Default Re: FAST-9999 Installaton Instructions


I need help. I have no power to my BTA10100 though I have sound from my head unit. If unplug & replug the fastbtah to the sub the sub's power light comes on but then turns off immediately.

I installed the fast9999 and fastbtah with my BTA10100 in my 2000 Mitsubishi Eclipse GT. I have an aftermarket powered head unit (with front, rear & sub outs) with all 6 wires of the fast9999 tapped between the factory wire & h/u. The blue/white wire (power antenna) on the fast9999 is connected to the factory wire but not into the head/unit as I have no external amp other than the bta10100 & whatever power the h/u puts out. Should the h/u be connected to the blue/white wire? Though the h/u has rca sub outs, I didn't connect them as the speaker wires are tapped from the harness. I grounded the fastbtah to the rear seat & sanded most of the paint. I have yet to sand the depression in the chassis right where the bolt goes. I suppose this could be it, but wanted to know about the blue/white wire.

Reply With Quote