View Single Post
Old 03-10-2011, 12:46 AM
ldtzbme's Avatar
ldtzbme ldtzbme is offline
Just Gettin Started
Join Date: Feb 2011
Posts: 8
Thanks: 0
Thanked 1 Time in 1 Post
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 11
ldtzbme is on a distinguished road
Default Re: bazooka tube identification

hey heavyduty
i was thinking of puting my factory radio back in my 98 gmc yukon, and was wondering about the FAST-9999 harness with posi-tap connectors. clearly states it will not work with the bta250d, but i was wondering if it will work just with the posi-tap connectors and cutting off the clip end and just twisting the wires together. I'm pretty sure this will work, but was wondering about the red and blue wires that are on this harness. The installation manual says the red is 12v power and obviously the blue is remote, but says you can use the power antenna wire. My truck does not have a power antenna and I already have the power cable ran from the battery back to the tube. The manual also says make sure to connect all 6 wires to the OEM harness. So in my case, I would not need the red 12v wire...right? The blue however I'm sure I need, but am just not sure which one to hook it to. Any ideas?
Reply With Quote